_ Insert the key fully into the console.
See HOW TO TURN ON THE POWER at the left.
B
Select the manual mode.
When the key is
inserted, the man-
ual mode will be
selected. If a pro-
gram has been se-
lected, reselect the
manual mode by
pressing the Select Program button repeatedly
until the track appears in the program display but
the indicator above the iFIT.com button is not lit.
iiiiiiiiiiiiiiiiii!i !iii ! iiiiiiiiiii !ii!ii!ii!ii! ii i!i!i ii iliiiiiiii!i!i !ii iiiiiiiiii ii
lPlug in the power cord.
See page 9.
B ove the reset/off circuit breaker to the reset
position.
Locate the reset/off cir-
cuit breaker near the
power cord. Make sure
that the circuit breaker
is in the reset position.
Reset
Position
D
Attach the clip to the waistband of your clothes.
Stand on the foot rails of the treadmill. Find the clip
attached to the key (see the drawing on page 10),
and slide the clip onto the waistband of your
clothes. Next, insert the key into the console. Test
the clip by carefully taking a few steps back-
ward until the key is pulled from the console. If
the key is not pulled from the console, adjust
the position of the clip as needed. Then, re-
move the key from the console.
Start the walking belt.
To start the walking belt, press the Start button,
the Speed + button, or one of the ten Quick Start
buttons.
If the Start button or the
Speed + button is
pressed, the walking belt
will begin to move at 1
mph. As you exercise,
change the speed of the
MP.
Km/H O
SPEED
walking belt as desired by pressing the Speed +
and - buttons. Each time a button is pressed, the
speed setting will change by 0.1 mph; if a button
is held down, the speed setting will change in in-
crements of 0.5 mph.
If one of the Quick Start buttons is pressed, the
walking belt will gradually increase in speed until it
reaches the selected speed setting. Note: The
console can display speed and distance in ei-
ther miles or kilometers. For simplicity, all in-
structions in this section refer to miles.
To stop the walking belt, press the Stop button.
The time will begin to flash in the Time/Pace dis-
play. To restart the walking belt, press the Start
button, the Speed + button, or one of the ten
Quick Start buttons.
Note: During the first few minutes that the treadmill
is used, observe the alignment of the walking belt,
and align it if necessary (see page 26).
11
To Next Page
Loading...
Need help?
General
