14
11. Attach the Pulse Crossbar (93) to the console
assembly with six #8 x 1/2" Screws (1); start all
six Screws, and then tighten them.
Then, firmly tighten the four 5/16" x 3/4" Screws
(4).
11
93
Console
Assembly
4
4
1
1
1
12. Check the gaps between the two handrail
assemblies (A, C) and the console assembly.
If necessary, loosen the #8 x 3/4" Screws (2)
under the handrail assemblies, slide the handrail
assemblies against the console assembly, and
then retighten the Screws.
Attach the Left Outside Upright Cover (87) and
the Right Outside Upright Cover (96) to the
Uprights (89) with two #8 x 1/2" Screws (1).
Note: Rotate the Outside Upright Covers
at an angle as you set them against the
Uprights. Do not overtighten the Screws.
12
96
89
89
1
1
87
2
C
A
2
Console
Assembly
To Next Page
Loading...
