9
9. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see page 27). To protect the floor or carpet
from damage, place a mat under the treadmill.
8. Slide the Right Upright Sleeve (96) against the
console assembly. Attach the Right Upright
Sleeve with two 3/4" Screws (4).
Attach the Left Upright Sleeve (not shown) to
the Left Upright (73) in the same way.
7. With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (83) into the cutout in the cardboard stand
a
s shown. Have the second person hold the
treadmill to prevent it from moving forward
o
r backward.
Firmly tighten the four Upright Bolts (72). With
the help of a second person, lower the treadmill
off the cardboard stand.
73
74
4
96
4
8
Cardboard
Stand
72
83
72
7
To Next Page
Loading...
