8
4. With the help of a second person, hold the con-
sole assembly near the Uprights (73, 74).
C
onnect the Upright Wire Harness (75) to the
Console Wire Harness (71). See the inset draw-
i
ng. The connectors should slide together
easily and snap into place. If they do not, turn
one connector and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Remove the wire tie from the Upright Wire (75).
71
Console
A
ssembly
4
75
Wire
Tie
74
5. Insert the brackets on the Handrails (99) into the
Right Upright (74) and the Left Upright (73).
Make sure that no wires are pinched.
73
5
74
99
6. Finger tighten three Handrail Bolts (64) with
three Upright Star Washers (90) into the Right
Upright (74). Next, finger tighten three Handrail
Bolts with three Upright Star Washers (not
shown) into the Left Upright (73). Then, firmly
tighten all six Handrail Bolts.
73
74
64
64
90
90
75
71
6
7
3
99
To Next Page
Loading...
