NordicTrack E 11.5 Elliptical - Page 11

11
9
9. Orient the Ramp Cover (131) around the Upright
(5) as shown.
Press the Mounts (not shown) on the underside
of the Ramp Cover (131) into the Ramp (130).
5
131
130
6
43
95
56
10. Apply grease to a Link Arm Axle (114).
Insert the Link Arm Axle (114) into the Right
Upper Body Leg (6) and the Right Link Arm (43)
from the side shown.
Insert a hex key into the M8 x 35mm Screw
(149) in the Link Arm Axle (114).
Using a second hex key, tighten another M8 x
35mm Screw (149), a Small Axle Cover (56),
and an M8 Washer (95) into the other end of the
Link Arm Axle (114). Tip: Avoid damaging the
Small Axle Cover when tightening the Screw.
Repeat this step on the other side of the
elliptical.
10
114
149
Grease
149