NordicTrack E 11.5 Elliptical - Page 13

13
13. Hold the Rear Upright Cover (25) near the
Upright (5) as shown.
Connect the receiver wire (A) on the Rear
Upright Cover (25) to the Receiver Extension
Wire (59).
Tip: Avoid pinching the wires. Attach the Rear
Upright Cover (25) to the Upright (5) with four
M4 x 19mm Screws (125).
13
14. Untie and discard the wire tie attached to the
Main Wire (60).
While a second person holds the Console (33)
near the Upright (5), connect the wires on the
Console to the Main Wire (60), to the Receiver
Extension Wire (59), and to the Pulse
Wires (105).
Insert the excess wire downward into the Upright
(5) or upward into the Console (33).
Tip: Avoid pinching the wires. Attach the
Console (33) to the Upright (5) with four M4 x
19mm Screws (125).
5
33
105
59
125
14
125
25
5
60
Avoid pinching
the wires
Avoid pinching
the wires
A
59