26
Next, locate the Reed Switch (60). Turn the Pulley (52)
until a Magnet (120) is aligned with the Reed Switch.
Loosen, but do not remove, the two indicated M4 x
16mm Screws (97). Next, slide the Reed Switch (60)
slightly closer to or away from the Magnet (120), and
then retighten the Screws.
Then, plug in the power cord, press the power switch
to the reset position, and rock the Pulley (52) forward
and backward just enough that the Magnet (120)
passes the Reed Switch (60) repeatedly. Repeat these
actions until the console displays correct feedback.
When the reed switch is correctly adjusted, press the
power switch to the off position and unplug the power
cord. Reverse the steps above and reattach the left
disc, the left pedal arm, the left upper body leg, and the
left roller arm. Then, plug in the power cord and press
the power switch to the reset position.
120
52
97
60
To Next Page
Loading...
