27
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted. First, press the power
switch to the off position and unplug the power
cord.
See EXPLODED DRAWING C on page 35.
Remove the M8 x 14mm Shoulder Screw (89), the
Roller Arm Cover (14), and the M8 Washer (103) from
the Right Roller Arm (39).
See assembly step 10 on page 10. Remove the
Upper Body Covers A and B (31, 32) from the Right
Upper Body Arm (25).
See assembly step 9 on page 10. Remove the
Right Upper Body Arm (25) from the Right Upper Body
Leg (26).
See EXPLODED DRAWING C on page 35 and
EXPLODED DRAWING B on page 34. First,
remove the Right Roller Arm (39), the Right Pedal
Arm (37), and the Right Upper Body Leg (26) from the
elliptical.
Next, using a flat screwdriver, gently pry off the right
Disc (29). Then, remove all the Screws (97, 98) from
the Right and Left Shields (35, 36); make sure to note
the location of each size of Screw. Gently remove
the Right Shield.
Locate and loosen the Pivot Screw (78). Next, tighten
the Adjustment Screw (75) until the Drive Belt (113) is
tight. Then, retighten the Pivot Screw.
When the drive belt is tight, reverse the steps above
and reattach the right shield, the right disc, the right
pedal arm, the right upper body leg, and the right roller
arm. Then, plug in the power cord and press the power
switch to the reset position.
78
113
75
To Next Page
Loading...
