NordicTrack FS5I - Page 9

9
4. Identify the Strap (64) on the Right Pedal Arm
(94). Route the Strap under the Roller (67);
make sure that the Strap is not twisted.
Make sure that the Glide Cables (62) on the
Right Pedal Arm (94) are resting on top of the
Roller (67) and that the Strap (64) is routed
under the Roller.
Tip: It may be helpful to have a second
person press downward on the Right Pedal
(11) while you perform the following action.
Attach the Strap (64) to the Cable Guide (12) on
the Right Pedal Arm (94) with three M6 x 20mm
Patch Screws (42) and a Strap Clamp (13); start
all the Patch Screws, and then tighten them.
Repeat this step on the other side of the
elliptical.
4
13
42
64
31
94
98
98
94
67
12
5
5. Attach a Pedal Arm Cover (31) to the
Right Pedal Arm (94) with two M4 x 16mm
Screws (98).
Repeat this step on the other side of the
elliptical.
62
11