11
Avoid pinching
the wires
6
4
110
1
7
4
1
92
92
110
6. Have a second person hold the Upright (4) near
the Frame (1) as shown.
Next, connect the Upright Wire (157) to the
Main Wire (110). IMPORTANT: Make sure to
connect the wires as described previously.
7. Avoid pinching the wires. Have a second
person hold the Upright (4) on the Frame (1).
Note: Two M10 x 25mm Screws (92) are
preattached to the Frame (1).
Attach the Upright (4) with two additional
M10 x 25mm Screws (92); do not fully tighten
the Screws yet.
See the inset drawing. Insert the connectors
on the wires into the left side of the Upright (4).
Next, route the Main Wire (110) through the
notch in the Grommet (156) as shown, and then
press the Grommet into the Upright.
157
4
156
110
To Next Page
Loading...
