13
10
11
Avoid pinching
the wires
7
10. Apply grease to one of the Pedal Arm Axles (64).
Insert the Pedal Arm Axle (64) into the Right
Upper Body Leg (60) and the Right Pedal Arm
(58) from the direction shown.
Next, slide an M8 x 22mm Washer (129) onto an
M8 x 13mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
Then, tighten the Pedal Arm Axle (64) and the
M8 x 13mm Screw (82) at the same time.
Repeat this step on the other side of the
elliptical.
82
129
60
64
Grease
58
4
110
111,
146
11. See step 7. Tighten the four M10 x 25mm
Screws (92).
While a second person holds the Console (7)
near the Upright (4), connect the wires on the
Console to the Main Wire (110) and to the Left
Extension Wire (111) and the Right Extension
Wire (146). IMPORTANT: Make sure to con-
nect the wires as described previously.
Avoid pinching the wires. Insert the excess
wire into the Upright (4).
92
92
To Next Page
Loading...
