17
19
65
60
101
66
19. See the inset drawing. Make sure that the Right
Control Wire (B) and the Right Extension Wire
(146) are in the exact positions shown.
Avoid pinching the wires. Orient the Right Arm
Front and Rear Covers (65, 66) around the Right
Upper Body Leg (60) as shown, and attach them
with two M4 x 16mm Screws (101). Make sure
to place the Extension Wire (146) in the indi-
cated area (E) of the Right Arm Rear Cover.
Repeat this step on the other side of the
elliptical.
18. Identify the Right Leg Inner Cover (83), orient it
as shown, and insert it through the Right Upper
Body Leg (60).
Next, identify the Right Leg Outer Cover (69),
orient it as shown, and press it onto the Right
Leg Inner Cover (83).
Attach the Right Leg Outer and Inner Covers
(69, 83) to each other with an M4 x 16mm
Screw (101).
Repeat this step on the other side of the
elliptical.
60
101
69
18
83
20. Make sure that all parts are properly tightened. Extra parts may be included. Place a mat beneath the
elliptical to protect the floor.
To register your product and activate your warranty today, go to my.nordictrack.com.
Avoid pinching
the wires
B
146
E
To Next Page
Loading...
