16
75
4
117
101
73, 74
17. Orient the Center Shield Cover (75) and the
Front Shield Cover (117) around the Upright (4)
as shown, and attach them to each other with
two M4 x 16mm Screws (101).
Avoid pinching the wires. Press the Front
Shield Cover (117) and the Center Shield Cover
(75) onto the Left and Right Shields (73, 74).
17
Avoid pinching
the wires
16
16. Identify the Right Upper Body Arm (61), orient it
as shown, and hold it near the Right Upper Body
Leg (60).
See the left inset drawing. Insert the Right
Extension Wire (146) into the Right Upper
Body Leg (60) and route it out of the indicated
hole (D).
Avoid pinching the Right Extension Wire
(146). Insert the Right Upper Body Arm (61) into
the Right Upper Body Leg (60). Attach the Right
Upper Body Arm with two M8 x 45mm Bolts (96)
and two M8 x16mm Washers (155).
See the right inset drawing. Connect the Right
Extension Wire (146) to the Right Control Wire
(B), and insert the excess wire into the Right
Upper Body Arm (61). IMPORTANT: For your
elliptical to function properly, make sure to
connect the wires as described previously.
Next, orient the Wires (B, 146) exactly as shown,
and attach a zip tie (133) around the Right Upper
Body Leg (60) in the location shown. Then, cut
off the excess zip tie.
Repeat this step for the Left Upper Body
Arm (47).
60
61
47
96
Avoid pinching
the wires
D
146
60
146
B
146
133
61
60
155
To Next Page
Loading...
