NordicTrack NTEL71423.2 - Installing Accessory Tray and Shields

15
14
14. Orient the Accessory Tray (37) as shown, and
attach it to the Upright (4) with two M4 x 16mm
Screws (101).
4
101
37
15
101
81
37
15. Make sure that the Right Control Wire (B) is
in the location shown.
Orient a Lower Tray Cover (81) as shown,
and hold it near the Right Control Wire (B).
Then, insert the Right Control Wire into
the notches (C) in the Lower Tray Cover as
shown in the inset drawing.
Avoid pinching the Right Control Wire (B).
Attach the Lower Tray Cover (81) to the right
side of the Accessory Tray (37) with two
M4 x 16mm Screws (101).
Repeat this step on the other side of the
elliptical.
Avoid
pinching
the Right
Control
Wire (B)
B
C
B
C
81