10
7. Have a second person hold the Console (84)
near the Yoke (88). Connect the Upright Wire
(72), the Left and Right Pulse Wires (70, 71),
a
nd the Console Ground Wire (89) to the wires
extending from the Console. See the inset
d
rawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Insert the excess wire into the Console (84).
7
84
89
71
72
70
72
8. Attach the Console (84) to the plate on the Yoke
(88) with four #8 x 3/4" Screws (1). Be careful
not to pinch any wires. Start all four Screws
before tightening any of them. Do not over-
tighten the Screws.
8
1
1
88
84
88
Console
Wires
Console Wire
To Next Page
Loading...
