7
2. Raise the Uprights (43) to the position shown.
Have a second person hold the console assem-
bly near the Uprights (43). Connect the Upright
Wire (93) to the 25" Wire Harness (101). See
the inset drawing. The connectors should
slide together easily and snap into place. If
they do not, turn one connector and try again. IF
THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Console
Assembly
2
93
43
101
101
93
43
96
1
96
9
6
96
1
1
1
1
1. With the help of a second person, tip the
Uprights (43) down as shown.
A
ttach the four Base Feet (96) to the bottom of
the Uprights (43) with four #8 x 1" Tek Screws
(
1) in the locations shown.
To Next Page
Loading...
