8
3
. Insert the excess wire into the right Upright (43)
as you set the console assembly on the
Uprights. Be careful not to pinch any wires.
A
ttach the console assembly with four 3/8" x
1 1/4" Bolts (2) and four 3/8" Star Washers (4).
Start all four Bolts before tightening any of
them.
Console
A
ssembly
3
4
4
2
2
4
2
4
2
43
4. Locate the Latch Assembly (88). Remove the
knob from the pin. Make sure that the collar and
the spring are on the pin. (Note: If there are two
collars, place one on each side of the spring.)
Next, insert the pin into the Latch Housing (89).
Then, tighten the knob onto the pin.
4
Pin
Spring
Collar
Knob
89
88
To Next Page