10
67
17
7
10
10. Identify the Right Pedal (7), and orient it as
shown.
Attach the Right Pedal (7) to the Right Pedal
Arm (17) with three M10 x 15mm Screws (67);
start all the Screws, and then tighten them.
Make sure to use the center hole and the two
outer holes to attach the Right Pedal.
Repeat this step on the other side of the
elliptical.
13
17
63
Grease
11
11. Apply a small amount of grease to an M8 x 76mm
Shoulder Screw (63).
Attach the front end of the Right Pedal Arm (17)
inside the bracket on the right Upper Body Leg
(13) with the M8 x 76mm Shoulder Screw (63).
Next, use an adjustable wrench to tighten a
Knob (15) into the Right Upper Body Arm (10).
Then, pull the Knob, slide the Upper Body Leg
(13) farther into the Right Upper Body Arm, and
release the Knob into one of the three adjust-
ment holes in the Upper Body Leg.
Repeat this step on the other side of the
elliptical.
15
10
To Next Page
Loading...
