9
6. With the help of a second person, carefully tip
the treadmill onto its side as shown. Partially
fold the Frame (54) so the treadmill is more sta-
b
le. Do not fully fold the Frame until the
treadmill is completely assembled.
Have a second person hold the Left Upright
(111) against the Base (85), with the bend in the
Left Upright positioned as shown. Slide the Left
Base Cover (118) onto the end of the Left
Upright.
Attach the Left Upright (111) to the Base (85)
with two 3/8" x 2 3/8" Bolts (10) and two 3/8"
Star Washers (18); do not fully tighten the
Bolts yet.
Attach a Wheel (92) to the indicated Extension
Leg (90) with a 3/8" x 2 3/4" Bolt (6) and a 3/8"
Nut (5). Do not overtighten the Nut; the
Wheel must turn freely.
6
10
92
5
18
85
1
18
90
111
Bend
8. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly.
Identify the Left Accessory Tray (93) and the
Right Accessory Tray (94), which are marked
with an "L" and an "R" on the bottom.
Attach the Left and Right Accessory Trays (93,
94) to the console assembly with eight #8 x 5/8"
Screws (7). Do not overtighten the Screws.
Console
Assembly
8
94
7
7
7
7
93
54
7. Slide the Left Base Cover (118) over the Base
(85). Attach the Left Base Cover with three #8 x
3/4" Screws (1). Do not overtighten the
Screws.
With the help of a second person, tip the tread-
mill so that the Base (85) is flat on the floor.
7
1
1
1
85
118
6
To Next Page
Loading...
Need help?
General
