Safety Instructions
I-3
4. Installation and electrical
connections
(continued)
l Cables must never be squeezed or pinched. They should be located
or positioned to eliminate the opportunity for an operator to stumble
or trip.
l A disconnect switch with lockout capability must be provided
between the power source and the equipment.
a
WARNING: If the installation is not carried out according to
t
instructions, especially in case of electrical connections, this
l
will result in imminent danger of serious personal injury
including death.
5. Operation
The unit should be operated according to relevant instructions and by
qualified personnel.
NEVER have the unit operated by personnel under the influence of
substances reducing their reaction times, or who are not able to
operate the equipment for physical reasons.
At regular intervals, check protective and warning devices to
determine that they are in a functioning condition. DO NOT
OPERATE THE UNIT IF THESE DEVICES ARE NOT
FUNCTIONING PROPERLY.
When the removal of safety equipment is required for installation,
maintenance, or repair of the unit, it must be reconnected
immediately upon completion of the work and prior to unit start-up.
In a humid environment, only equipment featuring a corresponding
class of protection may be operated.
Do not operate the unit in an explosive environment.
Keep endangered parts of the body or clothing away from rotating
parts. Take off wrist watches, rings, necklaces, or similar pieces of
jewelry and pin up or cover long hair before performing any work on
or with the unit.
To carry out measurements on work pieces, switch off the unit and
wait until it comes to a standstill.
Never point hand guns or applicator nozzles at yourself or other
persons.
Action in the even of unit
malfunction
Danger of burns
In the event the unit experiences a malfunction, switch off the unit
immediately.
l Switch off the main switch or, if available, the emergency turnoff
switch or use other safety equipment to stop the unit.
l After turning the unit off and prior to switching it on again, the
malfunction has to be eliminated by qualified personnel.
Contact with hot areas of the hot melt applicator as well as to the hot
melt material may produce a severe skin burn.
l Take utmost care when using hot melt material. Even solidified
material may still be very hot.
8 Nordsm Corporation 1995
All Rights Resewed
PIN 106 7018
41-2300SP - Issued 1195
To Next Page
Loading...
