Safety Instructions
I-5
7. Cleaning
(continued)
l
Note the flash point of the cleaning solvent used. Only use a
controlled heating method to heat solvents.
l
Ensure sufficient room ventilation to draw off generated vapors.
Avoid prolonged breathing of vapors.
WARNING: Fire, open lights and smoking are prohibited
when cleaning solvents are used. Risk of explosion or fire.
Failure to observe may result in personal injury or death.
8. Thermoplastic hot melt
material
NOTE: Always refer to the Material Safety Data Sheet or material
information sheet before working with the material.
l
Ensure the work area is adequately ventilated.
l Do not exceed recommended processing temperatures. Doing so
creates a danger to personnel due to decomposition of the material.
Q Nordson Corporation 1994
All Rights Reserved
PIN 106 701A
41-2300SP - Issued 1194
To Next Page
Loading...
