Ins talla tion 3-5
Manual gun installation
(continued)
Tgure 3.7 - Pivot Sleeve Details:
7 Pivot sleeve shell
2 Hose covering (note corrugation)
6. Connect wires 3 and 5 (the smaller diameter wires) extending from
the end of the hose to the ceramic terminal block on the same side
of the pivot sleeve as the ground connection. (The’ RTD is connected
to this terminal block.)
.
7. Connect wires 1 and 2 (the larger diameter wires) extending from the
end of the hose to the ceramic terminal block on the opposite side of
the pivot sleeve from the ground connection. (The heater cartridge,
which is larger than the RTD, is connected to this terminal block.)
NOTE: Be sure that these connections are made correctly. Connecting
the wires incorrectly may cause an electrical short and damage the
equipment.
8. Route the ground wire and wires 3 and 5 down the recessed slot
which is nearest the ground connection in the pivot sleeve.
9. Route wires 1 and 2 down the recessed slot on the opposite side of
the pivot sleeve.
10. Replace the wire retaining clip.
NOTE: Make certain that all wires lie flat and side by side, not crossing
each other within the slot.
11. Replace the pivot sleeve shells, making sure to clamp them around
at least three corrugations of the protective covering on the hose
(see Figure 3.7).
12. Secure the shells with four screws.
13. Install the handgun hose support bracket on the underside of the
applicator base before the applicator is bolted down. (This bracket is
shipped with the hose. Instructions for installing it come with it.)
NOTE: Do not permit the hose to drag on the floor. Nordson offers a
Handgun Hose Hanger Kit (P/N 271 486) to prevent this from
happening. Note that there must be a place where the hanger can be
suspended.
0 Nordson Corporation 1994
All Rights Reserved
PIN 106 701 A
41-23oOSP - Issued l/94
To Next Page
Loading...
