4-2
Operation
2. Preparation of equipment
1. Verify that the air pressure to the pump reads zero (0) on the gauge.
0 PSI (0 BAR)
2. Use a metal or plastic scoop to fill the adhesive tank with clean
material.
3. Close the applicator tank lid immediately to prevent the introduction
of contaminants.
4. Set all temperature controls to the recommended temperature
settings for the adhesive being applied.
5. Turn the external power supply ON.
6.Turn the main electrical switch ON at the applicator.
NOTE: The tank and hose(s) will begin to heat up first, as indicated by
the lit yellow LED for each channel. As the tank and hose(s) reach
setpoint temperatures, the gun(s) will begin to heat, as indicated by the
lit yellow LED for each gun channel. As a channel reaches setpoint
temperature, the yellow LED will begin to flash.
7. After the adhesive material in the tank becomes molten, remove the
nozzles from the guns.
PM 106 701A
41-23OOSP
- issued 1194
0 Nordson Corporation 1994
All Rights Resewed
To Next Page
Loading...
