5-4
Preventive Maintenance
Filter assembly cleaning
(continued)
NOTE: Do not use a metal brush to clean the filter screen. A metal
brush may damage the screen.
b. Heat the filter screen with a flameless electric heat gun. Wipe it
with a clean, dry cloth.
c. Use an ultrasonic cleaner filled with solvent to clean the filter
screen.
10. Inspect the screen for damage. Replace the screen if there are any
dents or breaks in the screen mesh.
NOTE: The applicator is shipped with a 0.006 inch (0.15 mm) mesh
filter screen. The size of the screen mesh should always be smaller
than the smallest gun nozzle.
11. Slide the screen over the core of the filter.
12. Insert the screw through the core into the filter bung and tighten the
screw.
13. Replace the O-ring with P/N 941 172.
14. With the applicator at operating temperature, screw the filter
assembly into the manifold and tighten.
4. Semiannual maintenance
Gun wiring inspection
Refer to the manual which accompanies the gun(s) being used with this
applicator.
Thrust bearing lubrication
(Handguns only)
Refer to the manual which accompanies the gun(s) being used with this
applicator.
P/N 106 701A
41-23OOSP
-Issued 1194
0 Nordson Corporation 1994
All Rights Resewed
To Next Page
Loading...
