Nordson 3500 Series User Manual

1
O1EN–10–[35–37C3]–6
Issued 9/94
Nordson Corporation
OPERATOR’S CARD
P/N 106 921A
Series 3500/3700
Hot Melt Material Applicator
with Piston Pump, MultiScanr Controller and Manifold C
Please Note
The operator’s card contains only information necessary
for daily operation and maintenance. For other
information, refer to the product manual.
A copy of this operator’s card and an order form for
another operator’s card are included in the Introduction
part of the operating manual.
WARNING: Allow only qualified personnel to
operate and maintain the unit. Observe the safety
instructions in the operating manual and the safety
symbols.
S Always follow the instructions given in the operator’s
card and operating manual.
S Always follow instructions in the material supplier’s
Material Safety Data Sheet (MSDS) or material
information sheet.
S Even at recommended operating temperatures, hot
melt material may release vapors. Exceeding
prescribed processing temperatures for long periods of
time can result in dangerous decomposition
by-products. Remove vapors by drawing them off with
an exhaust system.
Safety Symbols
The following symbols warn against dangers or possible
sources of danger. Become familiar with them! Failure to
heed a warning symbol could lead to personal injury
and/or damage to the unit or other equipment.
WARNING: Failure to observe may result in
personal injury, death, or equipment damage.
WARNING: Risk of electrical shock. Failure to
observe may result in personal injury or death.
WARNING: Disconnect equipment from line
voltage.
WARNING: Hot! Risk of burns. Wear
heat-protective clothing, safety goggles, and/or
heat-protective gloves depending on the symbol or
symbols shown.
WARNING: Pressurized system or material.
Release pressure. Failure to observe may result in
serious burns.
1. Turn the motor OFF.
2. Trigger all guns or adhesive head.
3. Open the manifold drain valve.

Nordson 3500 Series Specifications

General

Brand	Nordson
Model	3500 Series
Category	Melting Machines
Language	English

Summary

Operator's Card Safety and Notes

Please Note

Provides essential information for daily operation and maintenance, referring to the main product manual for other details.

General Safety Symbols

Explains warning symbols to prevent personal injury and equipment damage from potential dangers.

Hot Material Burn Warning

Warns about burn risk from hot materials and recommends protective clothing and goggles.

Electrical Shock Hazard

Warns of electrical shock hazard and potential for injury or death.

Pressurized System Warning

Alerts to pressurized systems and the need for pressure release to avoid burns.

System Components and Startup Procedures

Overview of System Components

Identifies and lists the main parts of the applicator and additional system components.

Daily Startup Procedure

Details the step-by-step process for starting the hot melt material applicator for daily operation.

Shutdown and Maintenance Tasks

Daily Shutdown Procedure

Outlines the necessary steps to safely shut down the hot melt material applicator.

Daily Maintenance

Describes routine maintenance tasks, including cleaning, checking seals, and flushing the manifold filter.

MultiScan Controller Functions

MultiScan Controller Overview

Details the components and indicators of the MultiScan Controller, including status and temperature controls.

Temperature Controls and Setting

Explains how to set and adjust temperature controls for different channels and notes for unused channels.

System Status Indicators

Describes the meaning of various LED indicators on the controller for system status and warnings.