Fulfill
Retrofit Kit − DuraBlue/VersaBlue 25L and 50L Melters
4
Part 1105309A
E 2010 Nordson Corporation
Instructions and Safety Messages
S Read and follow the instructions provided in this document and other
referenced documents.
S Familiarize yourself with the location and meaning of the safety warning
labels and tags affixed to the equipment. Refer to Safety Labels and Tags
at the end of this section.
S If you are unsure of how to use the equipment, contact your Nordson
representative for assistance.
Installation Practices
S Install the equipment in accordance with the instructions provided in this
document and in the documentation provided with auxiliary devices.
S Ensure that the equipment is rated for the environment in which it will be
used and that the processing characteristics of the material will not create
a hazardous environment. Refer to the Material Safety Data Sheet
(MSDS) for the material.
S If the required installation configuration does not match the installation
instructions, contact your Nordson representative for assistance.
S Position the equipment for safe operation. Observe the requirements for
clearance between the equipment and other objects.
S Install lockable power disconnects to isolate the equipment and all
independently powered auxiliary devices from their power sources.
S Properly ground all equipment. Contact your local building code
enforcement agency for specific requirements.
S Ensure that fuses of the correct type and rating are installed in fused
equipment.
S Contact the authority having jurisdiction to determine the requirement for
installation permits or inspections.
Operating Practices
S Familiarize yourself with the location and operation of all safety devices
and indicators.
S Confirm that the equipment, including all safety devices (guards,
interlocks, etc.), is in good working order and that the required
environmental conditions exist.
S Use the personal protective equipment (PPE) specified for each task.
Refer to Equipment Safety Information or the material manufacturer's
instructions and MSDS for PPE requirements.
S Do not use equipment that is malfunctioning or shows signs of a potential
malfunction.
To Next Page
Loading...
