Why is my Nordson Dispenser system overfilled?
If your Nordson Dispenser system is overfilled, it could be due to several reasons. The solenoid may be stuck open, in which case you should clean or replace it. Also, check if the sensor ground wire is not connected and connect it. If the refill board isn't working, replace it if it's defective. Finally, the sensor might not be calibrated properly, so you should calibrate the sensor.
What to do if my Nordson ProBlue Fulfill Dispenser system is underfilled?
If your Nordson Dispenser system is underfilled, there could be several reasons. Here's what you can check: * Ensure there's adhesive in the storage bin; add some if it's empty. * Make sure the unit has power. * Dislodge any adhesive bridging and consider adding an optional vibrator kit if the problem continues. * Inspect for clogs or kinks in the wand, hose, or lid, and replace parts if needed. * Replace a clogged filter sock. * Ensure the lid is closed and the lid switch is working. * Verify sufficient air pressure (minimum 65 psi static, 45 psi operating). Replace the regulator if it's defective. * Check that the level sensor has power (LED should be lit) and the power cord is properly installed. * Repair or replace a bent deflector. * Verify power to the control bo...
Explains how the fill system adds adhesive to the melter tank.
Details automatic and manual modes for fill system control.
Guides through connecting inputs/outputs and adjusting parameters.
Provides steps to verify the fill system is operating correctly.
Procedure for clearing refill alarms and resuming operation.
Instructions for calibrating the level sensor for accurate filling.
Lists part numbers for standard and splash-resistant kits.
Details technical data like operating temperature and air consumption.
General| Application | Packaging, product assembly |
|---|---|
| Control System | Touchscreen Interface |
| Power Requirements | 50/60 Hz |
| Connectivity | Ethernet |
| Certifications | CE, UL |
| Type | Hot melt adhesive dispenser |
To Next Page