Nordson ProBlue Fulfill - Fulfill System Specifications; Technical Data

ProBlue Fulfill Integrated Fill System
39
Part 1101094_02
E 2012 Nordson Corporation
Technical Data
Fulfill System Specifications
The following specifications are specific to the Fulfill integrated fill system.
For general ProBlue melter specifications, refer to the melter manual.
Parameter Specification
Melter operating temperature range 40-205 _C ( 104-400 _F)
Adhesive forms
Maximum size
Pellets, pastilles, mini-slats
S Pastilles: 12 mm (0.472 in.) diameter
S Mini-slats: 12 mm X 12 mm (0.472 in. X 0.472 in.) in length
Adhesive transfer maximum rate 227 kg (500 lb)/hour (dependent on adhesive type)
Transfer hose length 4m(13ft)
Operating air Minimum: 4.5 bar (0.45 MPa or 65 psi)
Maximum: 8.6 bar (0.86 MPa or 125 psi)
Air line tubing size (between
solenoid valve and suction lance)
10-mm OD, 8-mm ID
Total air consumption Full system not including optional tote vibrator: 680 l/min (24 scfm)
Optional tote vibrator: 283 l/min (10 scfm)
Conditioning Dry, non-lubricated
Inlet air connection ¼-in. NPT female
¼-in. BSPP female
G ¼ female
Pump type Venturi
Noise emission 76 dBA
Suction lance dimensions (L) 615 mm x (W) 105 mm maximum
(24.21 in. x 4.14 in. maximum)
Adhesive storage bin capacity 60 Kg (132 lb)