ProBlue Fulfill Integrated Fill System
13
Part 1101094_02
E 2012 Nordson Corporation
Assemble the Lid Components
See Figure 8. Install the filter enclosure, filter sock and inlet tube on the tank
lid of the Fulfill melter.
1. Remove the three M4 socket-head screws (5) and spacers (6) from the
tank lid assembly (7).
2. Insert the inlet tube (4) and rotate it to the desired position.
3. Reinstall the spacers (5) and socket-head screws (6).
4. Remove the tag from the filter sock (3).
5. Insert the filter sock (3) into the filter enclosure (1).
6. Set the filter enclosure on top of the tank lid and snap the filter enclosure
locks (2) onto the lid.
5
4
1
2
3
6
7
Figure 8 Fulfill lid assembly components
1. Filter enclosure
2. Filter enclosure locks
3. Filter sock
4. Inlet tube
5. M4 socket-head screw
6. Spacer
7. Melter tank lid
To Next Page
Loading...
