ProBlue Fulfill Integrated Fill System
24
Part 1101094_02
E 2012 Nordson Corporation
Level Sensor Adjustment and Calibration
The level sensor consists of a level probe and a control box. The level probe
has a black line around its diameter near the tip to note the maintained
adhesive level.
The level sensor comes pre-adjusted at the factory. This adjustment will be
suitable for most applications. Follow these procedures only if the settings
from the factory require adjustment for your application.
CAUTION! Do not raise the fill line of the probe above 2 inches from bottom
of the probe holder. Doing so will degrade the level sensor's performance.
1
2
Figure 12 Location of the level sensor amplifier light and adjustment screw
1. Level sensor amplifier 2. Level adjustment screw (covered
by plug)
To Next Page
Loading...
