ProBlue Fulfill Integrated Fill System
12
Part 1101094_02
E 2012 Nordson Corporation
Installation Components
In addition to the components contained in the melter installation kit, the
Fulfill system is shipped with the components shown in Figure 7.
NOTE: These components are shipped inside the adhesive storage bin.
Refer to Installation Kit Parts under Parts for component part numbers.
12 34
56
789
Figure 7 Fulfill system components shipped inside the adhesive storage bin
1. Adhesive storage bin (tote)
2. Transfer hose (standard)
3. Suction lance
4. Airline(4m)
5. Inlet tube
6. Hose clamp (2)
7. Wire tie (5)
8. Filter housing
9. Filter sock
Note: Extension kits are available if longer hose/air line lengths are needed. Refer to Parts for the extension kit part
numbers.
To Next Page
Loading...
