ProBlue Fulfill Integrated Fill System
7
Part 1101094_02
E 2012 Nordson Corporation
Overview of Electrical Components
The integrated Fulfill system includes a Fulfill-specific control panel. A refill
board located inside the electrical enclosure and a level sensor located
inside the tank control fill system operation.
(F). Control Panel
The Fulfill control panel shown in Figure 3 provides the following controls and
indicators:
S (1) Refill alarm symbol a nd LED (red light)—Activates if the system
exceeds the user defined fill time limit. The system will not resume
operation until the fault is cleared by pressing the Clear Fault key.
S (2) Adhesive transfer LED (blue light)—Indicates adhesive delivery is
active. When a low level is detected, the indicator notes that adhesive
is being transferred from the adhesive storage bin into the melter tank
through the transfer hose.
S (3) Fill system enable key and LED (green light)—Pressing the fill
system enable key turns the fill system on or off. The LED turns green
when the system is enabled.
3
2
1
Figure 3 Fulfill system controls and indicators
1. Refill alarm symbol and LED
2. Adhesive transfer LED
3. Fill system enable key
(on/off) and LED
To Next Page
Loading...
