ProBlue Fulfill Integrated Fill System
19
Part 1101094_02
E 2012 Nordson Corporation
Remove th e Inlet Air Deflector (Optional)
The inlet air deflector redirects the incoming air away from the tank surface.
The deflector is an optional part that is used in most applications in which the
adhesive in the top of the tank stays primarily or fully molten. In some
applications, better performance is achieved without the deflector.
NOTE: If the inlet tube is clogging, Nordson Corporation recommends
removing the air deflector.
See Figure 11. To remove the inlet air deflector, open the tank lid and
remove the deflector screws (1) and the deflector (2).
2
1
Figure 11 Removing the inlet air deflector
1. Deflector screws 2. Deflector
To Next Page
Loading...
