1
2
3
ProBlue Fulfill Integrated Fill System
16
Part 1101094_02
E 2012 Nordson Corporation
Set Up the Fill System
Fulfill system setup involves connecting inputs/outputs and adjusting system
parameters as desired. If no changes are needed, skip to the next
procedure, Test the Fill System.
1. Refer to the Fulfill system parameters shown in Table 2 and make
changes to the parameters as desired. Refer to To change a Fulfill
system parameter as needed.
2. Connect inputs/outputs as desired for your operation. Refer to Table 3 for
available inputs/outputs. Refer to the installation section of the melter
manual for the procedures for connecting and setting up inputs/outputs.
NOTE: For ProBlue Fulfill melters (generation 1) with fill system controls in
the sub-base, refer to manual P/N 1081444.
To change a Fulfill system parameter
SeeFigure10.
1. Press the Setup key.
The left display flashes parameter 1.
2. Using the numeric keypad, enter (or scroll to) the desired parameter.
Refer to Table 2 For Fulfill system parameters or to Table 3 for
parameters that need to be changed for any inputs/outputs.
NOTE: If you incorrectly enter the parameter number, press the
Clear/Reset key to return to parameter 1 and then re-enter the correct
parameter.
3. Press the Enter key.
4. Using the numeric keypad, enter the new value for parameter.
5. Press the Enter key.
6. Press the Setup key to exit the setup mode.
7. Test the system.
8. When you are satisfied that the fill system is operating correctly, save all
of the current melter setting into memory by simultaneously pressing the
number 1 key and the Setup key.
Figure 10 Keys used for
parameter setup
1. Setup key
2. Clear/reset key
3. Enter key
To Next Page
Loading...
