Nordyne E2 Series - User Manual

IMPORTANT: Read this owner information
to become familiar with the capabilities and
use of your heating appliance. Keep this
literature where you will have easy access to
it in the future. If a problem occurs, check
the instructions and follow recommenda-
tions given. If these suggestions don’t
eliminate your problem, call the appropriate
NORDYNE distributor. A distributor service
list is included with this appliance.
!
WARNING:
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Improper installation, adjustment,
alteration, service or maintenance can
cause injury, property damage, or
death. Refer to this manual. For
assistance or additional information
consult a qualified dealer or service
agency. To avoid personal injury or
property damage, ask a service
technician to inspect the furnace and
to replace any part of the control
system which has been under water.
SECTION 1. OWNER
INFORMATION
OPERATING INSTRUCTIONS
Before Operating System
Before operating your heating/cooling system
(see Figure 1), make sure that:
• Control panel covers are closed.
• Blower and/or relay control plugs are
plugged in.
• Fan switch is set to “AUTO” (E2EH units
only).
• Circuit breakers are in “ON” position.
!
CAUTION:
No user serviceable parts inside
control panel. DO NOT OPEN.
• All power supply switches for furnace and
outside unit (if installed) are turned on.
• Furnace door is closed and properly latched.
Refer to the owner’s manual supplied with the
optional heat pump or air conditioner for further
information.
Owners Manual/Installation Instructions
E2 Series
(Air Conditioner/Heat Pump Air Handler)
Downflow, Upflow Electric Furnaces

Summary

Owner Information and Operation

Operating Instructions

Covers system setup, operating modes, and basic usage of the furnace.

Maintenance Guidelines

Details on routine, semi-annual, and seasonal maintenance procedures for optimal performance.

Pre-Service Troubleshooting

A guide to common issues and checks before contacting a service professional.

Optional Cooling System Compatibility

Information regarding the furnace's compatibility with optional air conditioners or heat pumps.

Installer Information and Specifications

General Overview and Model Information

Introduction to furnace models, general installation notes, and overview of E2 series.

Codes, Specifications, and Requirements

Details on applicable codes, installation clearances, and technical specifications.

Installation Procedures

Comprehensive steps for unit checkout, downflow, upflow, and electrical system installation.

Wiring Diagrams and Connections

Includes wiring diagrams for various models and thermostat connection guides.

Nordyne E2 Series Specifications

General

Brand	Nordyne
Model	E2 Series
Category	Furnace
Language	English