Legend:
IFM – Fan Motor
CB – Circuit Breaker
E – Heater Element
Seq – Sequencer
IFR – Fan Relay
LS – Limit Switch
– Fan Plug
– Control Plug
NOTES:
1) See unit data label for recommended supply wire sizes.
2) Thermostat anticipator setting: 0.20 Amps.
3) To change blower speeds on units without a relay box refer
to installation instructions.
4) Refer to furnace and/or relay box installation for thermo-
stat connections.
5) If any wire in this unit is to be replaced it must be
replaced with 105°C thermoplastic copper wire of
the same gauge.
6) Not suitable for use on systems exceeding 120V to
ground.
7) This wire is used with some accessories. See acces-
sory Installation Instructions for further details.
Figure 25. E2EB 012 Wiring Diagrams