8
STOP OR PAUSE THE SESSION
To stop the session at any time, tap the play/pause button. This will pause the session. To restart your paused session, tap
the play/pause button again.
If you are done using the system, remove the attachments from the hose, remove the attachments from your limbs, turn o
the device by pressing the power button, and disconnect the hose from the device.
To disconnect connectors from the junction box or the device, push the button on the top of each connector while pulling
away.
FINISH THE SESSION
The session will continue massaging until time runs out and the display reads 0:00:00. The time indicator will blink, and the
device will continue until the current cycle is finished.
When the session is completed, remove the attachments from the hose, remove the attachments from your limbs, turn o the
device by pressing the power button, and disconnect the hose from the device.
To disconnect connectors from the junction box or the device, push the button on the top of each connector while pulling away.
TURN OFF THE DEVICE
To turn o the system, press the power button and confirm that the green power LED is o.
USE ZONE BOOST
During your session, you can increase the intensity of a single zone with the Zone Boost
feature. Zone Boost is designed to be used when you want extra attention in a specific
area. Zone Boost will add an extra 60 seconds of massage time, as well as 10 mmHg
increased pressure, in the selected zone.
Zone Boost can only be enabled during a session. Only one zone can be boosted at a
time. Zone Boost is only available with the patented NormaTec Pulse massage pattern.
Boosted zones will appear with the Zone Boost indicator on either side of the boosted
zone (figure 1) on the device’s screen.
Activate Zone Boost: When the zone you want to boost is flashing on the screen of
the device, tap the Zone Boost button. Zone Boost will be enabled for the flashing
zone, and the Zone Boost indicators will appear on either side of the zone (figure 1).
Deactivate Zone Boost: At any time when Zone Boost is active, tap the Zone Boost
button. Zone Boost will be disabled, and the Zone Boost indicators will disappear from
the screen. Zone Boost can also be disabled by powering o the device.
ADJUST THE REST TIME
To enter rest time edit mode, set the time to 10 minutes then hold down the time adjustment button for four seconds (until
the blue rest time indicator lights up and begins blinking).
When in rest time edit mode, the rest time will blink on the screen. Use the
and time adjustment buttons to increase or
decrease the rest time. The rest time can be set between 15 and 90 seconds in 15-second increments. The default rest time
is 30 seconds.
To save and exit rest time edit mode, tap the play/pause button on the device.
CHANGE THE MASSAGE PATTERN
The massage pattern can be set to NormaTec Pulse or Sequential. If the device is set to Sequential mode, it will be displayed
under the session time. To enable and disable the Sequential massage pattern, set the device to Level 7 and then hold the
level button for five seconds.
Figure 1: Example of zone three
boosted.
To Next Page
Loading...
Need help?
General
