PULSE User Manual
13OPERATING INSTRUCTIONS
WARNING!
BEFORE OPERATING THIS DEVICE: Read all warnings at the beginning of this manual.
If you do not understand these Operating Instructions, contact NormaTec at 866.658.5896.
SETUP THE SYSTEM
Step 1: Plug the NormaTec power supply into an electrical outlet and then into the PULSE Control Unit.
This device is equipped with a lithium ion battery. The battery automatically charges when the
power supply is connected to the PULSE Control Unit and an electrical outlet.
Step 2: Connect the long end of the NormaTec Hose to the Air Outlet on the front of the PULSE Control
Unit. The connector can only be inserted in the correct orientation. Press the connector firmly into the
PULSE Control Unit until you hear an audible “click.”
Step 3: Put the Attachment on (leg, arm, or hip). For a leg, hip, or an arm appliance, sit down, put the
appliance on, and sit in a reclined or supine position. If the Attachment has a zipper, be sure to zip-up
the Attachment completely. (Never try to use the system with the zipper partially or totally unzipped.
This could void your warranty.)
Step 4: Connect the Attachment Connectors on each Attachment to the Junction Box Air Outlets. The
Attachment Connectors can only be connected to the Junction Box in the correct orientation. Press the
Attachment Connectors firmly into the Junction Box Air Outlets until you hear an audible “click.”
If only one Attachment will be connected to the Junction Box, use the Blocking Plug located on
the underside of the Junction Box to block o the unused Junction Box Air Outlet. Press firmly to
make sure the Blocking Plug is fully seated.
Step 5: Press the Power Button on the PULSE Control Unit to turn on the system. The green LED next
to the Power Button and the screen will light up.
ADJUST THE INTENSITY AND TIME
Adjust the intensity level of the session by pressing the Pressure Adjustment Buttons on the left and
right of the screen.
Intensity level 1 is the gentlest setting. The massage becomes stronger as the intensity level is
increased to a maximum intensity level of 7.
Pressure can be adjusted while the session is running. To change the pressure during a
session press the Pressure Adjustment Buttons to select the desired pressure. The system will stop
for 10 seconds and the cycle will restart at the new pressure.
Operating Instructions
PULSE User Manual
To Next Page
Loading...
Need help?
General
