Nortek RC - 1.4 Introduction of special functions

3DJH
User’s Manual of Remote Controller
sequence:
（
2
）
Setting temperature
In unit on status, press
button to increase setting temperature and press
button to decrease setting temperature. The range of temperature is from 16

to 30

.
Note: Under auto mode, manual adjustment of temperature is not needed.
（
3
）
Adjusting fan speed
In unit on status, press FAN button to adjust fan speed in following sequence:
Notes:
①
.
When operation mode changes, fan speed is memoried;
②
.
Under dry mode, fan speed is low and can not be adjusted.
（
4
）
Setting swing function
 Setting left&right swing
1
）
Under simple swing status, press button to adjust left&right swing
status;
2
）
Under fixed-angle swing status, press button to adjust left&right swing
angle circularly as below:
Note: operate continuously left&right swing in 2 seconds, swing states will change
according to above-mentioned order, or switch closed state and
state.
 Setting up&down swing
1
）
Under simple swing status, press button to adjust up&down swing
status;
2
）
Under fixed-angle swing status, press button to adjust up&down
swing angle circularly as below: