In measuring state, if “DISP” showed on the bottom left of screen, indicating that
the measuring site has magnetic disrupt as shown below:
Please calibrate compass then measure again or far from the magnetic field to
make the measurement result more accurate
In measurement state, if no key operation in 30s, it will exit measurement
automatically and return to standby state.
In compass mode, if no any key operation in 3 minutes, it will exit and return to
normal time mode automatically.
If first use compass or measuring in another field and found compass is not correct,
please calibrate compass again (please refer to the next section Compass Calibration)
“0” degree means due north, rotating watch to make 12H point at other direction，
can measure the degree and direction that per magnetic north “0” as benchmark.
N-NNW –NW-WNW-W-WSW-SW-SSW-S-SSE-SE-ESE-E-NNE-NE-NNE）
The meaning of acronym displayed on the LCD screen
Direc�on Meaning Direc�on Meaning Direc�on Meaning Directio
Meaning
N North NNE North North-East NE Northeast ENE East North-East
E East ESE East South-East SE Southeast SSE South South-East
S South SSW South South-West
SW Southwest WSW West South-West
W West WNW West North-West NW Northwest NNW North North-West
Bottom left of
screen show
“DISP”
5
To Next Page
Loading...
