If the compass measurement still not correct after auto calibration by using
above method, please use digit compensation correction as below:
In compass mode, press and hold C Key for 3s, it display “ CAL ” and indicate
enter calibration mode. Press B Key to enter compensation correction state, at this
moment, press C or D Key to input east or west 0~90 degrees.
Press B Key for 2s to confirm and return to compass mode.
In calibration state, if no any key operation in 1 minute, it will exit automatically
and return to compass mode.
Compass Calibration：
Compass compensation correction：
In compass mode, press and hold C Key for 3seconds to display “ CAL ” , means
entering calibration mode. Press D Key to enter calibration state, at this moment,
please rotate watch more than 2 circles slowly（Rotate horizontally, both clockwise
and anticlockwise are ok）
Press D Key to confirm and return to compass mode.
In calibration state, if no any key operation in 1minute, it will exit and return to
compass mode automatically.
6
To Next Page
Loading...
