3.Click on the watch model to match.
4.The Bluetooth pairing takes only one time, and the watch will be
automatically connected to the phone once pairing successfully.
The iPhone pops up a notification whether to pair with the watch
and whether to allow the watch to receive notifications from the
phone.
5.If a watch cannot automatically connect to the phone after a
successful match, try unbinding the watch in the APP and ignoring
the watch in the Bluetooth settings of the phone; then reenter the
APP to bound watch.
6.If the above operations cannot solve problem for bounding,
long press the BACK button for 10 seconds to reset the watch,
and then enter HPlusFit APP binding watch again.
9.Sync with your phone:
The movement data of the watch will be transmitted to HPlusFit
via Bluetooth. The following points should be noted when
transmitting the data to HPlusFit:
1.Before uploading the motion data, you need to pair the watch
with the phone successfully.
2.Make sure the phone’s Bluetooth is enabled before uploading
the motion data.
3.By reading the watch’s data from your phone and running an
- 6 -
To Next Page
Loading...
