2 Installation
Before you start:
● Make sure the device in the package is in good condion and all
the assembly parts are included.
● The standard power supply is 12V DC, please make
sure your power supply matches with your camera.
● Make sure all the related equipment is power-off during the
installaon.
● Check the specificaon of the products for the installaon
environment.
● Make sure that the wall is strong enough to withstand fou
r
mes
the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay aenon to
the following precauons to prevent IR reflecon:
● Dust or grease on the dome cover will cause IR reflecon.
Please do not remove the dome cover film unl the installaon
is finished. If there is dust or grease on the dome cover, clean
the dome cover with clean so cloth and isopropyl alcohol.
● Make sure that
there is
no reflecve surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflecon.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are aached seamlessly.
To Next Page
Loading...