Nortrac 40XT - Page 100

Appendicies
94
SN
Standard
Code
Name and
Model
Installation Position
Quantity
Note
7
GB/T 308
Steel ball
8.0000G100b
Gearbox shift shaft
4
Steel ball 9.5V
Shfit shaft for the
power output rear axle
1
Steel ball
8.7312G400b
Steering arm of front drive
2
Locking shaft of the lifter
1
Steel ball
18.0000G100b
Braking disc and
Differential bearing block
12
8
GB/T 309
Needle φ5×25.8
Planetary gear shaft of final drive
(up to 52 horsepowers)
264
Rollingφ6×23.8
Planetary gear shaft of final drive
(55-60 horsepowers)
264
9
JB/T
7918-1997
Bearing
K20×26×20
Between the auxiliary shift
driven shaft and Shaft II
1
NOTES:
1. Before choosing the farm implements, you should refer to this detailed list and base your decision on the
working conditions (requirements of soil resistance, agronomy and so on) of the area. Choose the categories
of supporting implements and then consult the distributors.
2. According to the purchased model of the tractor (power capacity) in combination with the working conditions
(requirements of soil resistance, agronomy and so on) of the working area, you should refer to the results of
the consultations to determine the models of farm implements you need for suitable support. If the supporting
equipment is not suitable, it will have an adverse impact.
3. Different working conditions (requirements of soil resistance, agronomy and so on) with the same working
efficiency of the implement can give different results. Please calculate the working speed, working width etc.
according to local working conditions.
NOTICE: Before using a farm implement with the tractor, the operator should read its ―operation
and maintenance manual‖ carefully and get familiar with its construction, performance and method of operation
so as to avoid machine damage and personal injury.