IMPORTANT ISSUES:
1. When a fast change coupler is not used, the seat hole should be protected with the spare dust cover.
2. The lifter and the hydraulic output valve cannot be operated at the same time.
3. After setting up the auxiliary hydraulic output connection, the operating handle should be set in the
neutral position; otherwise, the hydraulic system could overheat.
4. The draft position control lever can control the 3-point hitch.
5. During the course of operation, only one lift handle should be used, and the other one set in the
lifting position.
WARNING:
Do not overload the tractor during traction operation or with a trailer. This can result in a loss
of performance and may shorten the service life of the tractor.
When braking, the trailer brake will apply slightly earlier than the tractor brake to prevent the load
from overturning.
To Next Page
Loading...
