What to do if the breaker on front panel trips in Nortron ECM Serirs?
If the breaker on the front panel of your Nortron Furnace trips, it indicates an overcurrent on the heating element. Try resetting the breaker. If the problem continues, it is recommended to call an electrician.
Why Nortron ECM Serirs is not providing enough heat?
If your Nortron Furnace isn't providing enough heat, check the following: Ensure the elements or relays are functioning correctly. Verify the SEASON SELECT switch is not set to the MILD position. Check for obstructions in the ductwork or dirty filters restricting airflow, which may cause safety limits to open. Inspect for a defective or incorrectly wired two-stage or outdoor thermostat. Ensure there are enough cold air returns in the house.
What to do if Nortron ECM Serirs will not turn off?
If your Nortron Furnace won't turn off, first turn the thermostat to its lowest setting. If the furnace continues to run even when there is no 24V between terminals C and W, then the thermostat has opened properly, and the problem is within the furnace itself. Otherwise, the issue lies with the thermostat or its wiring.
How to troubleshoot Nortron Furnace if it will not start?
If your Nortron Furnace will not start, turn the thermostat to its highest setting. If 24V is present between terminals C and W, the thermostat has closed, and the fault is in the furnace. Otherwise, the thermostat or its connecting wiring is the problem.
Why does the thermal cut-out open in Nortron ECM Serirs Furnace?
If the thermal cut-out opens in your Nortron Furnace, it means airflow is reduced because of blocked ductwork or very dirty filters.
What to check if Nortron ECM Serirs will not turn on?
The following components could be the cause if your Nortron Furnace will not turn on: the thermostat, an open circuit breaker or fuse, the motor or capacitor, the SPEED SELECTOR switch (open contact), the electronic control, or the transformer.
What causes elements to be on, but motor not running in Nortron ECM Serirs?
If the elements are on, but the motor does not run in your Nortron Furnace, check the motor or capacitor, the SPEED SELECTOR switch (for an open contact), and the electronic control.
Why does the motor run continuously in Nortron ECM Serirs Furnace?
If the motor in your Nortron Furnace runs continuously, check if the thermostat wires are incorrectly attached to the furnace.
What causes motor to cycle on and off in Nortron ECM Serirs?
If the motor in your Nortron Furnace is going on and off in short (or long) cycles, the heat anticipator in the thermostat may be incorrectly set or defective.
Why the thermostat must be set much higher than desired temperature in Nortron ECM Serirs Furnace?
If the thermostat must be set much higher (or lower) than the desired house temperature in your Nortron Furnace, it could be that the thermostat is not leveled or is out of calibration.
Details on attaching the duct to the furnace for air return.
Requirements for power supply wiring and ground conductor connection.
Steps for connecting and setting up the low voltage thermostat.
How to use two-stage or outdoor thermostats with the furnace.
Guidelines for adding air conditioning to the furnace system.
Details on operating 120V accessories with the furnace.
Connecting the furnace with other devices like wood burning furnaces.
To Next Page
General
