997-492-000-5, Issue 5
June 2009
ii
EN 54 & ISO 7240 2-8 Zone Conventional Fire Panel - Installation & Configuration Manual
6.3.4 2-Way Relay PCB (Optional) ................... 16
6.3.5 8-Way Relay PCB (Optional) ................... 16
6.3.6 4-Way Sounder PCB ................................ 16
6.4 Powering the Panel ....................................... 17
6.4.1 Standby Batteries ..................................... 17
6.5 Configuration and Handover ......................... 20
6.6 Commissioning Tests .................................... 20
6.7 Zone Wiring .................................................. 20
6.8 Sounder Circuits ........................................... 22
6.9 Digital Inputs ................................................. 23
6.10 Fault Finding Chart ....................................... 24
7 Configuration
7.1 Procedure ..................................................... 25
7.2 Panel Options - A .......................................... 26
7.2.1 Engineering Mute ..................................... 26
7.2.2 Commissioning Mode .............................. 26
7.2.3 ACCEPT Pushbutton Access Level ......... 26
7.2.4 LAMP TEST Access Level ....................... 26
7.3 Panel Options - B .......................................... 26
7.3.1 Non-latched Faults ................................... 26
7.3.2 Pulse Fire Routing outputs ....................... 26
7.3.3 FBF Fire Routing disable - forces off ....... 26
7.3.4 Re-sound - new zone in alarm ................. 26
7.3.5 Mains Fault delay ..................................... 27
7.4 Configuration ................................................. 27
7.4.1 Checksum ................................................ 27
7.4.2 Select Default Configuration .................... 27
7.5 Fire Zone Input Type ..................................... 28
7.5.1 Latching/ Non-latching Alarms ................. 28
7.5.2 Short-circuit Input Operation .................... 28
7.5.3 Auto/ Manual Zones ................................. 28
7.5.4 Coincident Detection ................................ 28
7.5.5 Sprinkler Verification Time ....................... 29
7.5.6 EOL Device Type ..................................... 29
7.6 Sounder Output Type/ Delay ......................... 29
7.6.1 Select Output ........................................... 30
7.6.2 Select Type .............................................. 30
7.6.3 Select Delay ............................................. 30
7.7 Digital Inputs ................................................. 30
7.7.1 Select Input .............................................. 31
7.7.2 Set Type ................................................... 31
7.8 Primary and Secondary Delays ..................... 32
7.8.1 Select Primary Delay Time ....................... 32
7.8.2 Select Secondary Delay Time .................. 32
7.8.3 Two-zone Override Delay......................... 32
7.9 Configuration Examples ................................ 33
8 Specification
9 Battery Calculation
Configuration Map ...................................... Back Page