16
English
www.novasina.com
4.3 Navigation in Sub-Menus
Navigation through the sub-menus is simple and only 4 different icons are
available to do it:
4.4
Menu "Chamber Settings"
All chamber related settings as stable observation time or calibration can
be done in this menu. If multiple chambers are connected, each chamber is
preseted via this submenu, just choose the respective chamber as active and
program the set-up afterwards.
The table below should give an overview about the available functions. Detailed
descriptions will be given thereafter.
Symbol Description Remarks
Close a sub-menu and return to
the menu above
Close all sub-menus and return to
the measurement screen
Move one menu point upwards
This icon is only displayed, if there are menu
points upwards the visible area
Move one menu point downwards
This icon is only displayed, if there are menu
points downwards the visible area
Menu point Description Remark Factory default setting
Temperature
control
Setting of measurement tempera-
ture control (or switch off)
Details see chapter 5.2. Off
Stable mode
Settings / Mode for stability obser-
vation time
Details see chapter 6.2 A (Average)
Stability
observation time
Programmable stability time, only
available if stable mode "Manual"
and "Query" have been selected
Details see chapter 6.2.2 5 min
Stability check
temperature
Monitoring of adherence of nomi-
nal temperature, only available if
stemperature control is activated
Details see chapter 5.2 On
Data logger
Sub-menu for programming the
logger and/or logging functions.
Details see chapter 7
Sample number: 0000
Interval recording: 10 sec
Sensor
calibration
Enter sub-menu for sensor
calibration
Details see chapter 8
To Next Page
Loading...
