NovaStar Thunderview S1 - Page 8

LED Display Controller Thunderview_S1
User Manual
3 Appearance
www.novastar.tech
4
pixels
SDI IN
Supports 3G-SDI progressive input in
standard format.
SDI LOOP
SDI loop out
Outputs
OUT1, IN1
OUT2, IN2

OUT1, IN1, OUT2 and IN2 are coaxial
output connectors.

OUT1 and IN1 are used in pairs. OUT2 and
IN2 are used in pairs.

Supported bandwidth of each channel is up
to 3G.

Loading capacity of each channel is up to
1920x1080@60HZ.

Maximum transmission distance of the
coaxial cable is 100m.
GenLock
In
It is the GenLock synchronization signal,
which is used to ensure synchronization
between the LED screen display and
external GenLock source.
Loop
GenLock loop out
Control
RS232
Baud rate: 115200 Bps
ETHERNET
RJ45 (TCP/IP) control connector
USB (Type-A)
Control connector that connects to the upper
computer
USB (Type-B)
Cascade connector
Power
100–240VAC@50/60Hz
AC power input
Switch
ON/OFF
Note:
The type-A USB port is prohibited from being connected to the upper computer directly.
XI'AN NOVASTAR TECH CO., LTD.