Novusun CNC NVBDH+ - Parameter Description

7^ At the standby page,press START button motor start to run,LED display the motor
speed,real speed=display speed*10.For example,when LED display 1020,then the motor speed
is 10200 R/Min.The LED 4 radixpoints take turns to flash,shows the motor run properly.
3.3 parameter description
1 Speed control mode P0
M ark P0 Speed control m ode default=0
value
rem ark
0 panel potentiometer speed control
1 external PWM speed control
2
external analog speed control
2 Start control mode P1
M ark P1
start control m ode default =0
value
rem ark
0
panel button start
CW/CCW start
3 External voltage control range P2
M ark P1
external voltage control range default =1
value
rem ark
0